Lab Notes · After you buy · Troubleshooting

LED light tubes only partly lit: the one-minute IC Set fix

A tube glows at the bottom and goes dark two-thirds of the way up. It looks like a dead strip. It is not — the controller has simply forgotten how many LEDs it is supposed to drive, and you can tell it again from the remote.

Saturn V (AR12C)LED remoteNo tools
Symptom

A light tube is lit only at one end; the rest is dark. Colour modes still cycle on the part that works. Often noticed right after delivery or after a power interruption.

Why it happens

The tubes are addressable LED strips. The controller stores a number — how many LEDs are in the chain — and only drives that many. Shipping vibration or a power cut can reset that number to a lower value, so the controller lights the first section and stops. No LED has failed; the strip is complete and waiting.

The fix

  1. Find the small LED remote — the one with the colour-swatch buttons. This is not the main jukebox remote; the two are easy to confuse.
  2. Press IC Set. The tubes turn white. That is the LED-count setting mode.
  3. Press the up arrow repeatedly. Each press lights a little more of the tube. Keep going until white fills the entire length of every tube.
  4. Choose any light mode. The lights now run full length, and the setting survives power-off.
Don't confuse it with radio mode. If the lights are off only while the jukebox is in FM radio mode, that is by design, not this fault — see the lights went off.

Notes

Official guides for this one

Manufacturer pages with photos, video and the manual — open these next.

Still stuck? The manufacturer's support team answers by email — send the order number and a short video of what the display shows.
Email our online support form

JukeboxLab is an editorial project of Hifun Design & Trading Inc., the company behind Arkrocket jukeboxes. We use Arkrocket machines as examples because we know them best; the principles apply to most modern jukeboxes. Nothing here replaces your owner's manual.